よくあるご質問
FAQ
Scanning Range Finder (Area Configuration Type)3D LiDAR

About output logic

YVTUSTURMUAMPBSUXMUGMUBGURGUTM

Please tell me about the output logic of the Scanning Range Finder.

Output is turned off when detected by the output logic “Active High” (default value) ,
the output logic “Active Low” can be set to turn on the output at the time of detection.
You can change it in the sensor settings with the application software. 
However, the fault output cannot be logically changed. 

BACK

Relation

FAQ's Category
Photoelectric Switch
3D LiDAR
Area Configuration Type
Optical Data Transmission Device
Sensor for Iron and Steel Industry
Area Configulation Type
Optical Remote Control Device
Auto Counter
Sensor for Textile Industry
Application
Laser Range Finder
Scanning Range Finder (Data Output Type)
Scanning Range Finder (Area Configuration Type)
FAQ's Tag
上に戻る