Archive タグ：URM

FAQ's Category

Photoelectric Switch

3D LiDAR

Area Configuration Type

Optical Data Transmission Device

Sensor for Iron and Steel Industry

Area Configulation Type

Optical Remote Control Device

Auto Counter

Sensor for Textile Industry

Application

Laser Range Finder

Scanning Range Finder (Data Output Type)

Scanning Range Finder (Area Configuration Type)

Archive タグ：URM

I am using UAM in ROS, but if I change the model to UST or URM, is it possible to substitute the software as it is?

Does the range sensor also support Linux?

About blocking when downloading application software

Why is the spread of the light beam different from the front and the side of the LiDAR?

Is there anything I can do if I don't know the IP address of the range sensor?

Is it possible to use the range sensor with Windows pro?

When was the time stamp acquired?

Is it possible to acquire data from multiple sensors at the same time?

How much communication data does the sensor have?

When I run an application that uses the URG library on a PC with low specifications, a communication error sometimes occurs.

I want to check the continuity of the tester with a wiring chuck in advance in order to light up the lamp using the output 1 of the URM-40LC-EW. Please tell me how to connect COM, output 1 and load correctly.

Are the vibration / shock resistance described in URM specifications implemented based on some international standards? If so, please disclose it. Also, are the standards also applied to other products?

Please tell me about the output residual voltage of URM and UST.

What is the leakage current of URM and UST?

What kind of output is synchronous output?

Do you need a exclusive driver for Ethernet type?

I connected to a PC, but it does not recognize the sensor. What should I do.

The optical window has become dirty. Please tell me how to clean it.

What is the difference between LX mode and LA mode?

Is it possible to use a USB conversion cable when setting the area?

How much can the cable be bent?

A white connector is attached at the time of delivery. Is this for making connection?

What is response time?

I created an area and wrote to the sensor, but why is it output even though there is no object in the area?

What happens if On-delay / Off-delay is set?

Please tell me how to set the hysteresis.

Please tell me how to connect to the output.

Is it possible to install the sensor upside down?

Does it work even if power is supplied from the battery?

What is contamination detection?

Are there any precautions to take when attaching a cover?

Is there any way to deliberately put the sensor in a malfunction state?

Sensor erroneously detect that there is an obstacle even though there is no object. Why it happens?

Please tell me about the output logic of the Scanning Range Finder.

Please tell me how to use the app.

Sensors Interfere with each other. Please tell me the measures.

I want to connect to a PC and edit the area with the application, but the sensor is not recognized. What should i do?

The light from the sensor is affecting other devices. Is there any measures?

Are the vibration / shock resistance described in URM specifications implemented based on some international standards? If so, please disclose it. Also, are the standards
also applied to other products?

I want to connect to a PC and edit the area with the application, but the sensor is not recognized.
What should i do?