Archive タグ：PBS

FAQ's Category

Sensor for Iron and Steel Industry

Area Configulation Type

Optical Remote Control Device

Auto Counter

Sensor for Textile Industry

Application

Laser Range Finder

Scanning Range Finder (Data Output Type)

Scanning Range Finder (Area Configuration Type)

Photoelectric Switch

3D LiDAR

Area Configuration Type

Optical Data Transmission Device

Archive タグ：PBS

Why does the signal of output 3 become uncertain when the area input of PBS-03JN is switched (including defects)?

If PBS-03JN is affected by ambient light or vibration, will the malfunction output basically turn off and outputs 1 to 3 also turn off?

Is there any software to transfer area data from PBS-03JN to UST-05LN?

About blocking when downloading application software

Why is the spread of the light beam different from the front and the side of the LiDAR?

Is area data written to PBS-03JN at the time of shipment?

Should the shielded wire of PBS-03JN be connected to ground?

Do you have a CD-R of PBS-03JN application software?

Does the PB9-13AN-01 application support the PBS application?

Is it possible to use the range sensor with Windows pro?

What is the difference between PBS-03JN and PBS-03JN-05?

Does the range sensor (PBS / UST / UAM) use OSSD?

What is the minimum detection object for PBS? Is a fingertip detectable?

The PBS configured area has disappeared. The power is on and the green indicator light is on, but it doesn't detect any obstacles entering the area.

Which side of the PBS optical window is the light emitting side, top or bottom?

What kind of output is synchronous output?

I connected to a PC, but it does not recognize the sensor. What should I do.

The optical window has become dirty. Please tell me how to clean it.

Is it possible to use a USB conversion cable when setting the area?

How much can the cable be bent?

A white connector is attached at the time of delivery. Is this for making connection?

What is response time?

I created an area and wrote to the sensor, but why is it output even though there is no object in the area?

What happens if On-delay / Off-delay is set?

Please tell me how to set the hysteresis.

Please tell me how to connect to the output.

Is it possible to install the sensor upside down?

What is the end of the RS232C connection cable for PBS?

Does it work even if power is supplied from the battery?

What is contamination detection?

Are there any precautions to take when attaching a cover?

Is there any way to deliberately put the sensor in a malfunction state?

Sensor erroneously detect that there is an obstacle even though there is no object. Why it happens?

Please tell me about the output logic of the Scanning Range Finder.

Please tell me how to use the app.

Sensors Interfere with each other. Please tell me the measures.

I want to connect to a PC and edit the area with the application, but the sensor is not recognized. What should i do?

The light from the sensor is affecting other devices. Is there any measures?

What is the minimum detection object for PBS?
Is a fingertip detectable?

The PBS configured area has disappeared.
The power is on and the green indicator light is on, but it doesn't detect any obstacles entering the area.

I want to connect to a PC and edit the area with the application, but the sensor is not recognized.
What should i do?